UniTrain Course – Automation Technology 2: PLC Model Lift Application

ABOUT THIS PRODUCT:

Includes:

Experiment board PLC trainer

• CPU with PLC functionality
• 8 digital inputs with simulation switches and status LEDs
• 8 digital outputs with status LED connected to 2 mm sockets
• 8 analog inputs with 10-bit resolution, of which 4 inputs 0-10 V and 4 inputs 4-20 mA
• 4 analog outputs, of which 2 outputs 0-10 V and 2 outputs 4-20 mA
• 1 potentiometer for simulation of an analog 0-10 V signal via 2 mm sockets
• 1 potentiometer for simulation of an analog 4-20 mA signal via 2 mm sockets
• LAN switch with three connection terminals
• 9-pin D-Sub socket with connection to digital inputs and outputs of the PLC
• 25-pin D-Sub socket with connection to digital inputs and outputs of the PLC
• Status LED of the PLC
• Browser and course software

Additionaly required for course:

• Model lift with three storeys
  • Illuminated call button for each storey
  • Three illuminated floor selection buttons in the lift cage itself
  • Direction indicators on each storey and in the lift cage
  • 7-segment floor indicators
  • Safety mechanism to prevent crushing of fingers by plexiglass front

Course contents:

• Manual control for motors
• Detection of sensor signals
• Lift control for two storeys
• Lift control for three storeys
• Lift control with door opening/closing
• Introduction to automatic stop functionality plus programming
• Course duration: 4 h approx.